Description; Features; First Setting Up - Laserworld Net OEM User Manual

1

Description

The lasershow output board Net OEM allows the control of ILDA-compatible lasershow
projectors by use of different lasershow control software via network connection.
There is no need for installing cards into PC-slots and Notebooks can be used to playback
lasershows.
The network media allows data transfer over long distance.
The use of TCP/IP-protocol allows the use of standard network hardware, like hubs, switches
and routers.
The board has an ILDA standard connector with symmetrical outputs for scanners.
The Net-19 features the Net OEM board in a plug and play 19 inch rack.
1.1

Features

• IEEE 802.3u 100BASE-TX Full duplex Ethernet interface
• Supports TCP/IP-Protocol and UDP
• Supports Auto MDI/MDIX (cable crossing)
• Supports Auto-IP (APIPA) and DHCP
• Supports UPnP (Plug and play)
• High performance system on chip with 32Bit-prozessor
• 32 megabytes RAM on board
• Maximum framesize 16.000 Coordinates
• Dual framebuffer for interruption-free output
• Jitterfree output for high stable output
• X/Y-output 14Bit, total 260 millions of coordinates
• Colour outputs RGB and Intensity 8 Bits each, 16 millions of colours
• Optional available with 6 colour channels + Intensity
• Outputspeed up to 150.000 points (coordinates) per second (150Kpps)
• 16 Bit digital outputs (3,3V logic level)
• IP-address selectable at DIP-switch (16 device addresses and 2 subnets)
• Single voltage power supply 9-12V DC /400mA reverse connection protected
• ILDA-standard connector with symmetrical X/Y-outputs
• Open driver-DLL (EasyLase compatible)
• Up to 16 cards can be used simultaneously
• DMX-support for 512 Channels input and output isolated optically
• Firmware update via network (web browser)
• Integrated colourshifting
• Integrated SD-card slot for standalone player function
Net-19 is a Net OEM installed in a 19 inch rack, wired ready to use. Some parts of this manual (like
the wiring) will naturally not apply the Net-19 version, these sections are in italics.
Important Note:
Net OEM supports one output channel for one laserprojector.
Multiple projectors can be connected to one Net OEM parallel and will output the same content.
If multiple projectors should output different content (channels) of a lasershow, more cards are
necessary, one for each different channel.
2

First setting up

3