8 Modulation Damper and Pressure Switches The fan damper is wired via a plug and socket arrangement. The socket is connected to the assembly via a bracket. Release the loose plug and FIXED CONNECTION remove the cap via two screws. SOCKET Connect incoming...
Page 11
(17mm) End Vent L104102 L104101 L104100 L104103 Orifice Plate (16mm) (24mm) (27mm) (28mm) End Vent Suction (All Models) Minimum Fire 0.5” to 1” WG Maximum Fire 2.5” to 3” WG Please contact an AmbiRad representative for installations over 4000’ elevation...
Page 12
12 SmartCom³ ARC Commissioning. For ease and swiftness of initial start-up, the immediately with standard Infrared Radiant SmartCom³ range of electronic controllers is heaters. supplied factory pre-set to default settings as described in the SmartCom³ Installation and To alter the control system to a single or multi-zone ARC systems and operated along User Manual ref US/SCOM/29.
Page 13
Notes: Remote Door Interlock MASTER & SLAVE (NETWORK) EXTERNAL / DOOR FROST ONLY When setting up a SmartCom³ Master and Slave (Network) system, the master controller will display error message during SmartCom³ controllers can be connect to a commissioning. This will clear once the door interlock, remote frost stat or permanent commissioning is complete.
Page 14
Fishers, Indiana 46038 Telephone 317-577-0337 Facsimile 317-842-3989 Website www.ambirad.com/us For the Distributor Nearest please AmbiRad is a registered trademark of AmbiRad Limited. Because of continuous product 1-888-330-4878 call innovation, AmbiRad reserves the right to change product specification without due notice.
Need help?
Do you have a question about the SmartCom3 and is the answer not in the manual?
Questions and answers