Troubleshooting Guide - EINHELL GE-SC 35/1 Li Original Operating Instructions

11. Troubleshooting guide

Fault
Motor does not start
Engine performance
drops
Imprecise scarifying
result
Motor is running,
roller is not
rotating
Important notice! To protect the motor itis equipped with a thermal overload switch which cuts
out when overloaded and starts again automatically after a short cooling-down period.
Anl_GE_SC_35_1_Li_SPK9.indb 29 Anl_GE_SC_35_1_Li_SPK9.indb 29
GB
Possible causes
a) Internal terminals disconnected
b) Safety lock-off defective
c) Scarifi er housing clogged
d) Safety plug is not connected
e) Battery is not correctly inserted
a) Soil is too fi rm
b) Housing clogged
c) Roller badly worn
a) roller worn
b) Wrong working depth
a) Toothed belt is torn
- 29 -
Rectifi cation
a) By customer service workshop
b) By customer service workshop
c) Change the scarifying depth if
necessary; clean the housing so
that the spike drum can move freely
d) Connect safety plug (see 6.)
e) Remove battery and insert again
(see 5.)
a) Change working depth
b) Clean housing
c) Replace roller
a) Replace roller
b) Correct working depth
a) By customer service workshop
20.03.2019 06:16:45 20.03.2019 06:16:45