Table of Contents
Advertisement
I
NSTALLATION
When using the mounting bracket, allow six inches (15.3 cm) on both ends of the ENIU for cable access. Install the
ENIU using the following procedures.
D
I
ESKTOP
NSTALLATION
Step
1
Remove the protective adhesive backing from the four feet. Position a foot on each bottom corner of the
ENIU. Press these firmly onto the ENIU.
2
Situate the ENIU in a way that provides both front and rear access. LEDs and Ethernet connections are
located on both ends. Power connection is located on the rear panel.
3
Connect the power supply to the DC IN connector located on the back of the ENIU:
– If using AC power, connect the power supply to the AC source (110 – 240 VAC, 50 – 60 Hz).
– If using DC power, connect the power following local practices. (See
Connections" on page
4
Verify that the STATUS LED is lit.
Infrared radiation is invisible and can seriously damage the retina of the eye. Do not look into the
DANGER
optical connector of an operational transmitter, or into the end of an active fiber. A clean,
protective cap or hood MUST be immediately placed over any radiating connector or optical fiber
to avoid exposure to potentially dangerous amounts of radiation. This practice also helps prevent
contamination of connectors and adapters. Do not assume laser power is turned off or the fiber
is disconnected at the other end.
S
M
URFACE
OUNT
An optional ENIU mounting bracket provides a number of options when securing the ENIU to a vertical or horizontal
surface. An ENIU can be installed facing up, down, right, or left when mounted on a vertical surface. The same
mounting bracket is also used to secure the ENIU to the bottom of a work surface.
Note:
Allow six inches (15.3 cm) on both ends of the ENIU for cable access.
Step
1
Situate the ENIU in a way that provides both front and rear access. LEDs and Ethernet connections are
located on both ends. Power connection is located on the rear panel.
2
Using the mounting bracket as a template, mark and drill holes in the mounting surface.
3
Secure the mounting bracket to the surface with appropriate fasteners for the surface material (#10 wood
screws or machine screws depending on the mounting surface).
4
Align the slots on the rear face of the ENIU with the mounting bracket. See
into the mounting bracket.
5
If not already installed, insert SFP into ENIU until you hear it click in place.
AIWN-UM-7001-01
2-2.) See
I
NSTALLATION
Action
Appendix A: Specifications
Action
Chapter
"Power and Ground
for fuse size.
Figure
2-1. Slide the ENIU
2
2-1
Advertisement
Table of Contents
