Transport Position After Work - Bonatti LSN Series Operation And Maintenance Manual

6.4. TRANSPORT POSITION AFTER WORK

As transport position after work we mean all those operations required to get the
Snow Blade in the correct position for circulation on any type of road.
6.4.1 Transport phase afer work
a) Lift the blade by operating the hydraulic levers of the farm
tractor.
If these operations are correctly performed, the Snow Blade can be
transported safely.
6.5. PARKING POSITION
With parking position we mean the Snow Blade in non-working conditions, that is
detached from the farm tractor and supported by the stabilizing foot. To get the
Snow Blade in parking position following procedures have to be followed.
Parking phase
a) Drop the blade to the ground
b) Stop the engine and release the flexible pipe pressure by operating the hydraulic
control of the farm tractor.
c) Disconnect the hydraulic flexible pipes from the rapid couplings.
d) By hand, lower the stabilizing foot and secure it with the special setscrew.
e) By hand, extract the pin of the third point coupling.
f) Manually remove the lock-split pin from the lower arms of the farm tractor
hoisting device.
g) Manually extend the hoisting device arms of the farm tractor until they are
extracted from the fixed support pin of the Snow Blade.
N.B. Take care that the blade is completely uncoupled from the hoisting device.
N.B. Make sure that the Snow Blade is positioned on a flat and suitable surface, in
order to prevent the Blade from turning over.
Start the engine of the farm tractor and go ahead or back up slowly, according with
the position of the Snow Blade compared with the farm tractor.
N.B. The Company Bonatti declines any civil and penal responsibility that may arise
from a wrong use of the Snow Blade in case of non-observance of the above
mentioned procedures.
-12-