Technical Specifications - Dell EqualLogic FS7600 Series Installation And Setup Manual

Dell EqualLogic FS7600 Installation and Setup Guide
• In North America, connect the appliance to a source of power with overcurrent protection provided by a
20 A or less device (UL 489 circuit breakers). In Europe, the overcurrent protection must be provided by a
20 A or less device (IEC circuit breakers).
• Make sure enough space is available for airflow in front of and behind the appliance.
• Make sure the location is properly vented.
• Review the technical specifications in the following section to make sure your environment supports the
requirements.

Technical Specifications

Table 2 lists the technical specifications for the NAS appliance.
Table 2: FS7600 NAS Appliance Technical Specifications
Category
AC Power Supply (per power supply)
Wattage
Heat dissipation
Voltage
Battery Power Supply
Battery
Physical
Height
Width
Depth
Weight (maximum
configuration)
Weight (empty)
Environmental
Operating temperature
Storage temperature
Operational relative
humidity
Rating
Output 717 W
2446 BTU/hr
The heat dissipation is calculated using the power supply wattage rating. The
heat dissipation values are for the entire system, which includes the chassis and two
controllers.
90 VAC to 264 VAC, autoranging, 47 Hz/63 Hz
This system is also designed to be connected to IT power systems with a phase to
phase voltage not exceeding 230 V.
12.8 V to 13.2 V, 4.8 Ah to 6 Ah, 63 Wh to 77 Wh
86.4 mm (3.4 in.)
481.5 mm (18.96 in.)—with rack flange
446.3 mm (17.6 in.)—without rack flange
813.0 mm (32.0 in.)—with bezel and handle
741.0 mm (29.2 in.)—without bezel and handle
30.5 kg (67 lb.)
12.86 kg (28.36 lb.)
Continuous operation: 5°C to 40°C (41°F to 104°F) with a maximum temperature
gradation of 20°C (68°F) per hour
–40°C to 60°C (–40°F to 140°F) with a maximum temperature gradation of 20°C per
hour
20% to 80% (non-condensing) with maximum humidity gradation of 10% per hour at
maximum wet bulb temperature of 29°C (89°F)
1 Before You Begin
5