Controls - Philips FW-V39/21M User Manual

CONTROLS

¡ n
– to connect headphones.
™ CLOCK•TIMER
– to view the clock, set the clock or set
the timer.
£ RETURN
– for VCD with PBC on to return to the
previous MENU level during playback
(for VCD version 2.0 only).
≤ PBC (PLAYBACK CONTROL)
– to switch on or off PBC mode (for VCD
version 2.0 only).
∞ A. REPLAY (AUTO REPLAY)
– to select playback mode either in
continuous AUTO REPLAY or ONCE
only.
§ DUBBING
– to dub a tape in normal speed.
≥ TAPE DECK 2
• TAPE DECK 1
ª OSD (ON SCREEN DISPLAY)
– to switch on or off the on screen
display on the TV screen.
º ZOOM
– to enlarge a still picture on the TV
screen (for VCD operation only) .
⁄ VOCAL
– to fade out the vocal of the original
song during VCD playback or to switch
between mono or stereo mode during
audio disc playback (for VCD operation
only) .
10
pg 01-28/V39/21-En 10
¤ KEY CONTROL ( I È i )
– to change the key to suit your vocal
range (for VCD operation only) .
I ................. to decrease vocal key
level.
È .................... to restore vocal key to
original setting.
i ................... to increase vocal key
level.
‹ ECHO -/+
– to adjust the echo level for karaoke
(for VCD operation only) .
› RESUME
– to continue playback again from
where you have stopped. Only when
PBC mode is switched off (for VCD
operation only) .
fi SLOW
– to watch a VCD at a slower speed.
There are 3 modes of selection (for
VCD operation only) .
fl A - B
– to playback a certain scene or passage
of a VCD/CD repeatedly.
‡ DIGEST
– to scan through a VCD or a particular
track. There are 4 modes of selection
(for VCD operation only) .
° REPEAT
– to repeat a disc track or the current
disc.
· DIGIT 0 – 9
(numbers consisting more than two
figures must be keyed in within 2
seconds.)
for VCD with PBC on ..........................
to select an entry level.
for VCD/CD/MP3-CD...to key in a disc
track to start playback
or
...................... to select another track
during playback or
...................... to select a track for
programming.
‚ B
– to switch the system to standby mode.
Notes for remote control:
– First select the source you wish to
control by pressing one of the
source select keys on the remote
control (e.g. VCD, TUNER, etc.).
– Then select the desired function
( É , í , ë , etc.).
6/8/01, 9:01 AM
3139 116 19982