Advertisement
R
epair
[2] DISASSEMBLY/ASSEMBLY FOR DC1851 U
[2]-1. Terminal unit and Charger case complete
DISASSEMBLING
Important: After disconnecting the charger from the power source, wait more than 5 minutes before repairing work.
Replace Charger case complete.as drawn in Figs. 5 and 6.
Fig. 5
1. Turn Charger upside down and remove
four tapping screws.
Fig. 6
3. Hold the connector on Charging circuit and pull up the connector.
Charging circuit
ASSEMBLING
Assemble Charger case complete to Charger case cover by
reversing the disassembly procedure.
Be sure to push Power supply cord firmly between the ribs
and the wall of Charger case cover as drawn in Fig. 7.
2. Turn Charger over again and open Charger case complete
from rear side.
Tapping screws
Indication of DC1851 U
Note: Terminal unit is fully integral with Charger case complete.
When it is necessary to replace Terminal unit, replacing
Charger case complete and Charging condition label is required.
Connector
*Open from
this side
Fig. 7
Power supply cord
P 4/ 5
Charger case complete
Terminal unit
Charger case cover
Advertisement
