Table of Contents
Advertisement
Manual preset programming
1
Press TUNER (BAND) repeatedly to select the
desired tuner band: FM or MW.
2
Press and hold 1 / ¡ on the system or on
the remote control to search a radio frequency.
3
Press PROGRAM.
➜
"PROG" and "P 00:00" will display.
4
Press O / P or numeric keys (0-9) to
select the desired preset number.
5
After selecting an address number, press
PROGRAM again to store the radio station.
●
Repeat steps 3-5 to store other preset radio
stations.
To stop storing the manual preset
●
Press 7 on the system.
Note:
– If you attempt to store more than 40 preset
radio stations, "FULL" will be displayed.
Selecting a preset radio station
●
In tuner mode, press O / P or use the
numeric keys (0-9) to select the desired
preset number.
➜
The preset number, radio frequency, and
waveband are displayed.
Deleting a preset radio station
1
Press O or P to select the preset radio station
to be erased.
2
Press 7 on the system, "PRESET DELETED"
appears on the display.
➜
The radio frequency remains on the display.
➜
The preset numbers of all other preset radio
stations in the band with higher numbers are
also decreased by one.
●
Repeat steps 1-2 to erase other preset radio
stations.
Tuner Operations
Changing tuning grid
In some countries, the frequency step between
adjacent channels in the MW band is 9 kHz (10
kHz in some areas). The preset frequency step in
the factory is 9 kHz.
1
Plug the AC power cord.
2
Press TUNER to select MW mode.
3
Press and hold 9 for more than 3 seconds on
the panel.
➜
"STEP XX K" appears.
Note:
– All preset stations will be lost and need to be
reprogrammed.
33
Advertisement
Table of Contents
