Installing The Water Dispenser - Waterworks B5 User Manual

Installing the water dispenser

Follow the instructions below to install the appliance.
CAUTION
• A fully filled water bottle is very heavy. Be careful not to drop the bottle while transporting, loading, or
unloading it as it may cause injury.
• Stretch your back naturally and bend your knees when lifting the water bottle to prevent injury.
• Depending on the individual, the water bottle may be too heavy to lift. If necessary, ask for assistance when
lifting the bottle.
1
Remove the protective seal from the bottle cap and
load the water bottle by lifting and inserting it onto
the water inlet, ensuring the bottle is fully aligned
with the appliance and centered over the water inlet.
CAUTION
• Do not remove the bottle cap as water may overflow
when loading the water bottle.
• Wipe up any water spills immediately after loading or
unloading the water bottle.
2
Open the hot water faucet until water flows via the
hot water faucet to fill the hot water tank.
3
Connect the power plug to the power outlet.
WARNING
Do not touch the cable or power plug if your hands are
wet. There is a risk of electric shock.
4
Turn on the hot water switch.
NOTE
When using the appliance for the first time or after
an extended period of time, the appliance may take
minimum of 1 hour to cool or heat water.
9