Preparations; Step 1: Inserting Batteries Into The Remote Control; Step 2: Setting The Clock - Philips FWD573/98 User Manual

IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
3
1
2
1
Open the battery compartment.
2
Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by "+" and "–" symbols.
3
Close the cover.
Using the remote control to operate the
system
1
Point the remote control directly
at the remote sensor (IR) on the
front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TAPE1/2, TUNER).
3
Then select the desired function (for example
2;, O or P).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.

Step 2: Setting the clock

The clock can be set in either 12-hour or 24-
hour mode ("PM 00:00" or "00:00" for
example).
1
The clock can be set in any source mode.
➜
If you have not set the clock, "--:--" will be
shown on the display.
2
Press and hold CLOCK and "00:00" blinks on
the display.
➜
The current time is flashing on the display.
➜
If you have not set the clock, "--:--" will appear
on the display.
3
Press O or P on the system to set the
hours.
4
Press 1 or ¡ on the system to set the
minutes.
5
Press CLOCK to confirm your setting. The
clock will be shown on the display for 5 seconds
and then the display will go back to its previous
status. The system will store the setting
automatically.
➜
The time setting becomes effective.
Note:
– In AUX mode, setting clock using remote control
is not possible.
To exit the setting without storing (in
standby mode)
● Press 9 on the system to exit.
➜
"CANCEL" will appear on the display.
●
Press STANDBY ON to exit setting mode and
go to POWER ON mode.
●
You can also press DISC, DISC1~3, DISC
CHANGE, OPEN/CLOSE to exit setting
mode and go to disc mode.
●
The system will also exit setting mode and go to
TUNER, TAPE or AUX mode when you press
the corresponding source button.
Viewing the clock in any source mode
●
When you have set the clock, press CLOCK on
the system to view clock. Press DISPLAY on
the system to toggle between 12-hour and 24-
hour modes.
➜
The time will be displayed for 10 seconds and
then the display will go back to its previous
status.

Preparations

19