Advertisement
BEFORE YOU BEGIN
BEFORE YOU BEGIN
!
Congratulation on your purchase of this high
quality Bathroom Accessory. Before
proceeding with the installation, please
carefully read this installation instruction in
order to ensure proper care and assembly of
this accessory.
!
Please keep this installation instruction for
future reference.
Prior to drilling into walls, check there
are no hidden electrical wires, cables or
water supply pipes with the aid of ar,
electronic detector. If you use power
tools do not forget:
1. Wear eye protection.
2. Unplug equipment after use.
ROUGHING-IN
Reference Value
1110777-T01-A
1110777-T01-A
1175612-T01-A
850
(
LIGHTING MIRROR W ANTI-FOG FILM
!
!
1.
2.
K-15478T
53
)
158
200436
ã
-1-
ã
Copyright Kohler China Ltd., 2011
Installation INSTRUCTIONS
K-15478T/K-15479T/K-45101T
UNIT : mm
, 2011
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Kohler K-15478T
Summary of Contents for Kohler K-15478T
- Page 1 If you use power tools do not forget: 1. Wear eye protection. 2. Unplug equipment after use. ROUGHING-IN Reference Value UNIT : mm K-15478T 200436 ã 1110777-T01-A 1110777-T01-A , 2011 1175612-T01-A ã Copyright Kohler China Ltd., 2011...
- Page 2 K-15479T/K-45101T K-15479T: 600 K-45101T: 900 Kohler reserves the right to change marked dimensions without prior notice. PREPARE THE SITE PREPARE THE SITE NOTE: 1. For the sake of your safety, please turn off the electricity before installation, dismantling or cleaning.
- Page 3 5. Connect the plug with the socket. 6. Fix the fluorescent lamp to the spring slice. Spring Slice Fluorescent Lamp Socket Plug 7. Drill through the pre-prepared hole on the lampshade. 8. Pull the waterproof wire clip through the pre- prepared hole on the lampshade.
- Page 4 11. Fix the lampshade on the mounting plate with screws. Note: The seal ring must be embedded into the lampshade. Lampshade Screw Mounting Plate 12. Pull the screw through the bracket and the mounting hole. Tighten the wall anchors. Screw 1 Bracket Installation Hole 13.
- Page 5 14. Fix the supporting block onto wall with screws. Tighten the wall anchors. Wall Anchor Supporting Block Screw 2 15. Connect the waterproof gasket with the socket and then tighten the socket with the plug. 16. Hang the hook to the bracket. 17.
Need help?
Do you have a question about the K-15478T and is the answer not in the manual?
Questions and answers