Dell OptiPlex 7440 Instructions page 2

2 Re-imaging Dell OptiPlex 7440 computer
Re-imaging the Dell OptiPlex 7440 computer
Introduction
Before you begin
Re-imaging the
computer
This topic describes how to re-image the Dell OptiPlex 7440
computer. Re-imaging will remove all software on the computer
and re-install the factory default Microsoft® Windows® operating
system. In the event that your computer fails or becomes
corrupted, use these instructions to re-image it.
Be sure to back up data files and personal information before
re-imaging the computer.
If applicable, make note of the network settings.
To re-image the computer:
1. Turn on the OptiPlex computer.
The system boots to the windows boot manager. You have
30 seconds to select either Windows 7 or Recovery.
2. Select Recovery to re-image the computer.
Note: If you do not make a selection within 30 seconds, the
system will automatically boot to Windows 7.