Table of Contents
Advertisement
RESET DEFAULT
To bring the dialer back to its starting condition, you must remove power supply, press the # key and keep it pressed to resume
power supply.
The dialer will ask you to choose the language (ITALIAN or foreign language), and will then run the initialization and will restore
all the parameters to the default factory settings.
Note: The reset Default does not cancel the voice messages (neither the ones pre-recorded in the factory nor any
messages recorded during installation)
LED FUNCTIONING LOGIC
The dialer is equipped with 3 signaling LED:
YELLOW LED = indicates that the GSM ENGINE is operating. When the initialization is over, it turns on permanently to indicate that
the engine is ready and is not performing any operation.
When making a call or sending an SMS, the LED will return to flash again and indicate that the engine is operating.
GREEN LED = it is usually off and flashes when you are making a sound recording.
RED LED = indicates that there is problem in the system:
permanently on = GSM engine locked, signal or network absent, sim locked by pin code, card tamper, tamper of inputs.
Flashes = low credit
PROGRAMMING
Type in the installer code (000000 default): the dialer automatically positions itself on the first menu.
Use the up and down arrow keys to scroll the various menus.
Press ENTER (✔) to change the menu.
Use the alphanumerical keypad to type in the names and numbers
Use the CANCEL key (✘) to cancel the parameters or to enable the assignment boxed frames
Use the # key to exit the menus and to return to the display in standby
MENU OF IN / OUT LINES
IN/OUT LINES --> NAMES
The name can be changed for each line, instead of the default one.
- Once you have accessed the menu, press ENTER to highlight the line name you want to change.
- Use the up and down arrows to choose the desired line, then press ENTER again
- Use CANCEL to cancel the existent name, type in the new NAME with the alphanumerical keys (the writing method is similar to
the one of cellphones without the aid of the T9 spelling alert). When finished, confirm with ENTER.
MENU OF IN / OUT LINES
IN/OUT LINES --> TYPE
With this menu you can assign the Type of operation concerned or signaling input or control output to the available lines.
- once you have accessed the menu, you can assign the following using the number keys or vertical arrows:
- = line not programmed
C = line configured as NC input
O = line configured as NO input
B = line configured as BALANCED input - Balanced with a 1Kohm resistance
U = line configured as OPEN - COLLECTOR output
www.amcelettronica.com
10
VOXOUT v. 1.2
Hide quick links:
Advertisement
Table of Contents
