TMC Aquarium REEF-FILTER 50 Instructions For Installation And Use Manual page 6

REEF-Filter instructions v1-2014_Layout 1 12/11/2014 11:50 Page 6
SET UP - REEF-FILTER NANO 50 & 100
• Insert pump into the centre of the base of the REEF-Filter.
• Remove the centre media chamber from the REEF-Filter.
• Remove the lid from centre media chamber, then remove the top sponge.
• Fill the centre media chamber with the required volume of media.
• Replace the sponge back in the centre media chamber and then replace the lid, ensuring the
seal is correctly positioned within its groove.
• Place the centre media chamber back inside the main REEF-Filter body.
• Using the body hanger, hang the REEF-Filter onto the aquarium or sump at the desired
height using the thumb screw to secure it in place.
• At the base of the reactor there is a built in flow control. By rotating the centre media
chamber you can adjust the flow and fluidising level. Start with the slide covering
the outlet pipe (fully closed postion - see NANO 8 below). This will ensure that your media
is not forced out of the reactor on start up.
• For fine tuning of water flow, you can also adjust the flow control dial on the pump (NANO 9).
• Periodically clean the internal sponges and chambers to ensure continued even flow.
NANO 1
NANO 4
NANO 7
NANO 2
NANO 5
Fully open
NANO 8
Fully closed
3
NANO 3
NANO 6
NANO 9