Advertisement
Produktgruppe 19
15 von 16
!
WTV,
.
.)
/
ru
am
Parts required
Quantity
Mat. no.
06889700
Installation Instructions
Note
For W 4000 and W 6000 washers with slanted fascias (72°) in combination with T 7000 dryers.
Warning!
Heat-pump dryers should be transported as shown in Fig. 2. If the dryer has not been transported in this fashion, it
should remain idle for at least one hour before reconnecting to the power supply. Otherwise, the heat pump could become
damaged.
A Place the frame with drawer on the washer lid.
A Align the frame so that its panel lines up with the washer's fascia.
A When removing the drawer, hold the frame securely in place with one hand. With the other hand, pull out the drawer, lift
it forward and remove.
A Mark screw points for the frame on the washer lid.
A Take off the frame.
A Apply silicone to the screw markings on the washer lid. Approximate diameter: 25mm / 1 inch. See Fig. 3, Pos. A.
A Place the frame back on the washer lid and adjust it so that it lines up with the washer's fascia.
A Secure the frame to the washer lid using the 10 wood screws; see Fig. 3, Pos. B.
A Condenser/heat-pump dryers: Empty the condenser box.
A Adjust the dryer feet to 14mm (9/16 ); see Fig. 3, Pos. C.
A Install the dryer in the guides on the frame; seeFig. 3, Pos. D.
A Install and secure the guide retainers; see Fig. 3, Pos. D.
A Insert the panels and snap them into place; see Fig. 3, Pos. E.
A Insert the drawer, push it in and then open it again.
A Snap the drawer into place by pulling on its retainers and the guide rail at the same time.
26.02.2014
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
,
:
,
Designation
Washer-dryer stack kit WTV 417
Umbau- und Montageanweisung
.
WTV,
. (
:
.
M.-Nr. 06958933
WTV:
.
Advertisement
