Advertisement
5. Checking the Items Before Climbing the Tower
Components and Cables
AP (with two RF cables)
a
AP antenna (with antenna support)
AP grounding clip
Outdoor shielded network cable
Optical module and outdoor optical
fiber (optional)
6. Installing and Aligning the AP Antenna
1. Use a compass to secure the antenna to the pole based on the position and azimuth specified
in the planning document.
2. Loosen the screws on the front clamp plate of the upper support, adjust the position of the front
clamp plate to the elevation angle specified in the network planning document, and then secure
the clamp plate.
Screws for securing the
front clamp plate
1. Before the installation, remove the rear clamp plate from
2. When fastening the support, ensure that the screw nut is
3. Fine adjust the azimuth and elevation of the AP antenna.
Front and rear
adjustment
Elevation
adjustment
slide
Azimuth
adjustment
NOTE
This document takes a sector antenna as an example of how to complete the quick installation,
similar to a flat antenna. For details about how to install an antenna, refer to the installation guide
of the vendor.
Tools and Documents
Auxiliary Materials
Hose clamp
Adjustable wrench
Binding strap
Diagonal pliers
Waterproof tape
M3 and M6 hex keys
ESD tape
Compass, mobile
phone
Planning document
NOTICE
one screw.
closely attached to the front clamp plate to prevent rotation
of the screw.
Rear clamp plate
Nut
NOTICE
1. Adjust the azimuth of the AP antenna as follows: Loosen
the fastening screws on the upper and lower supports,
move the antenna horizontally leftwards and rightwards
until the antenna's azimuth measured by the compass
reaches the planned value, and then secure the fastening
screws.
2. Adjust the elevation of the AP antenna as follows: Loosen
the fastening screws on the angle ruler on the upper
support, slide the screw on the angle ruler until the scale
on the angle ruler reaches the planned value (you can
use a gradiometer to achieve better accuracy), and then
secure the fastening screw.
7. Installing the AP
Pole
AP mounting
bracket
Hose clamp
AP
Outdoor cable
tie
AP grounding
clip
Connecting to the outdoor ground
bar or tower (the antirust paint
needs to be removed)
3. Install AP grounding clips.
8. Installing Cables
GE(o) port
RF port (H)
COMBO(e) port
Outdoor optical
fiber (optional)
Outdoor network
cable (optional)
1. Secure the mounting bracket to the
corresponding position on the pole using a hose
clamp. Secure the excess part of the hose clamp
using cable ties.
AP mounting bracket
2. Insert the attachment plate behind the AP into
the slot of the mounting bracket, and secure the
AP to the mounting bracket using screws on the
top of the attachment plate.
Attachment plate
a
b
RF port (V)
P&E port
RF port (V)
RF port (H)
Outdoor
network cable
RF cables
Advertisement
