Sealey VS8812 Instructions Manual page 7

4.6.3. Key Beep Set
the default setting is Beep on.
1) from System Setup screen, use the ScroLL button to select Key Beep Set and press the enter button.
2) from Key Beep Set menu, use the ScroLL button to select Beep on or Beep off to turn on/off the beep.
3) Press the enter button to save your selection and return to previous menu.
4.6.4. Status Beep Set
different audio tone corresponds to different Led lamp. this function is invaluable when working in bright areas where Led
illumination alone is not sufficient.
1) from System Setup screen, use the ScroLL button to select Status Beep Set and press the enter button.
2) from Status Beep Set menu, use the ScroLL button to select Beep on or Beep off to turn on/off the beep.
3) Press the enter button to save your selection and return to previous menu.
4.6.5. Fn Key Set
from System Setup screen, use the ScroLL button to select fn Key Set, and press the enter button.
In this menu, you could configer the Fn setting for one-click function.
during the operation in any menu or interface of the tool, once press the fn key, it will come up the setting menu. one-click
function.
use the ScroLL button to select usual datastream mode, All datastream mode, I/m readiness mode, read codes mode. then
press the enter button to save your selection and return to previous screen.
1) usual datastream mode
In this mode, the tool has recommend some datastream as important datasteam for the user reference, during the vehilcle's monitors
have run and completed their diagnosis and testing.
2) All datastream mode
In this mode, after the vehicle's monitors have run and completed their diagnosis and testing, the scan tool will return to check all data-
stream. So it is mostly used to check the monitors' status.
3) I/m readiness mode
I/m readiness mode is the default work mode. In this mode, after the vehicle's monitors have run and completed their diagnosis and
testing, the scan tool will turn to eoBd diagnostic procedures.
4) read codes mode
read codes mode is the basic work mode. In this mode, after the vehicle's monitors have run and completed their diagnosis and
testing, the scan tool will read the trouble codes.
to exit the Setup menu
use the ScroLL button to select Previous menu from the System Setup screen, and press the enter button to return to main
Screen.
© Jack Sealey Limited © Jack Sealey Limited
Key Beep Set
off
on
Status Beep Set
off
on
fn Key Set
usual datastream
All datastream
I/m readiness
read codes
Original Language Version Original Language Version
1/2
1/2
1/4
VS8812 | Issue 1 27/02/17 VS8812 | Issue 1 27/02/17
Page 6