Samsung CLP 500 Instructions Manual page 5

12. Locate the FUSE that is soldered to the two outer contact
tabs.
14. Use the solder iron to smooth out any solder material remain-
ing on the outer contact tabs.
NOTES:
www.uninetimaging.com
11124 Washington Blvd., Culver City, California U.S.A. 90232 Ph: 310 280-9620 • Fx: 310 838-7294 • techsupport@uninetimaging.com
© 2006 Uninet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UNINET IMAGING INC. • SAMSUNG CLP 500 REMANUFACTURING INSTRUCTIONS
Remove
Ph:
Fx:
Uninet Imaging does not guarantee or warrant downloaded information.
13. Use pliers to hold the FUSE while applying the heated solder
iron to the tab connected to it as shown. Carefully remove the
wire as the solder melts. Repeat the same on the other tab. DO
NOT OVERHEAT the tab as this may cause the housing to melt.
15. Solder the CARTRIDGE RESET SYSTEM FUSE onto the outer
contact tabs as shown. You can solder any side to either contact
as the tabs are not specific. Be careful not to overheat the tabs.
USA EUROPE
+310-280-9620 +34-93-757-1335
+310-838-7294 +34-93-741-4166
JAPAN BRAZIL
+81-3-44-55-2789 +55-11-4822-3033
+310-838-7294 +55-11-4822-3353
ARGENTINA
+54-11-4571-2388
+54-11-4574-3706