Advertisement
2. Drill a hole (9/32 inch) through the frame at each
marked location.
3. Install the left shield bracket on the left frame
using 2 bolts (1/4 x 3/4 inch) and 2 locknuts (1/4
inch) as shown in
Figure 3
1. Bolts (1/4 x 3/4 inch)
2. Left shield bracket
4. Install the right shield bracket on the right frame
using 2 bolts (1/4 x 3/4 inch) and 2 locknuts (1/4
inch), similar to
Figure
Figure
3.
3. Locknut (1/4 inch)
3.
3
Assembling the Operator
Shield
Parts needed for this procedure:
2
Shield support
1
Shield
8
Bolt (1/4 x 1-1/2 inch)
8
Washer
8
Locknut (1/4 inch)
Procedure
g202825
1. Assemble the shield and flexible skirt to the
shield supports, as illustrated in
8 bolts (1/4 x 1-1/2 inch), 8 washers, and 8
locknuts (1/4 inch).
1. Locknut (8)
2. Washer (8)
3. Shield
4. Bolt (8)
2. Slide the shield supports into the pockets in the
shield brackets on the traction unit
Note:
The skirt should drape over the engine
or hood.
3
Figure
4, using
Figure 4
5. Skirt
6. Shield support (2)
7. Shield bracket (2)
(Figure
g202842
4).
Advertisement
