Advertisement
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Lower the loader arms.
4. Shut off the engine and remove the key.
2
Installing the Shield
Brackets
Parts needed for this procedure:
1
Right shield bracket
1
Left shield bracket
4
Bolt (1/4 x 3/4 inch)
4
Locknut (1/4 inch)
Procedure
1. Measure in from the edges of the frame as
illustrated in
Figure 2
of the holes for mounting the shield bracket on
both sides of the machine.
Note:
If the holes exist, skip to step 3.
and mark the locations
Figure 1
1. 7.0 cm (2-3/4 inches)
2. 5.7 cm (2-1/4 inches)
3. 1.3 cm (1/2 inch)
2
Figure 2
4. Holes
5. Reference bar
g036689
g213269
Advertisement
