Pronteau PROBOIL 3 Descaling Manual

Scan here to
link to a video
demonstration
The filter system provided with PROBOIL will help to prevent of the calcification (scaling) of the boiler. However it will be
required from time to time that the PROBOIL will need to be descaled, drained and refilled to ensure the maximum
energy efficiency and service life from the product especially in hard water areas. Descaling solutions can be obtained by
contacting the service agent shown on the label on top of the boiler.
Ensuring that the filter system is set up correctly and replaced as required will reduce the frequency of descaling
required. If you are regularly needing to descale the PROBOIL system then you either need to replace the filter more
frequently or check the bypass setup of the filter system.
WARNING: Harmful if swallowed. Irritating to eyes and skin. KEEP OUT OF REACH OF CHILREN.
Avoid contact with skin and eyes. In case of contact with eyes, rinse immediately with plenty of
water and seek medical advice. After contact with skin, wash immediately with plenty of water.
If swallowed, seek medical advice immediately and show this container or label.
Ingredients: Sulfamic Acid. Country of origin USA. See
information and SDS.
⚠
The descaling chemical is acidic and should only be used and handled as indicated, care should be taken not to
ingest, expose to skin, clothing or decorative surfaces. Take care when touching all surfaces and when disconnecting or
connecting hoses they may be hot and or generate steam, you must use personal protective wear to prevent accidental
scalding.
1. If required, adjust the PROBOIL temperature
to 80°C (see user guide
Only If the boiler is already set to a
temperature higher than 80°C then dispense
at least 1 litre from the boiler using the key
fob, now allow the boiler to fully fill and
heat. Once completed then switch off the
PROBOIL at the front control panel (see user
guide / powering down
2. Wait until the flexible connector (B9) has
cooled to a safe touch temperature, this may
take some time.
⚠
3. Ensure the flexible connector (B9) is
cool to the touch before proceeding,
afterwards unscrew by hand the flexible
connector (B9) from the top of the boiler.
Wear suitable gloves to ensure your safety.
for more details).
for more details).
PROBOIL.
Descaling Guide
www.proboil.co.uk for further
Proboil descaler guide v1-0a