Table of Contents
Advertisement
Quick Links
C
ONTENTS
Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Important User Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
General. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Manufacturer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Intended Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Required Tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Parts and Fastener List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-6
Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Please read and understand these Assembly Instructions before working with or using the Attic.
If you need additional information about the Attic, contact Wenger Corporation using the information
below.
©Wenger Corporation 2008
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnesota 55060-0448
Questions? Call.....USA: (800) 733-0393 • International (call collect): (507) 455-4100 • www.wengercorp.com
Attic Storage System
Printed in USA 04/08
Assembly Instructions
Part #259A098-01
Advertisement
Table of Contents
Related Manuals for Wenger Attic Storage System
Summary of Contents for Wenger Attic Storage System
-
Page 1: Table Of Contents
Installation......... 7 Please read and understand these Assembly Instructions before working with or using the Attic. If you need additional information about the Attic, contact Wenger Corporation using the information below. -
Page 2: Safety Precautions
ARRANTY The Attic Storage System is guaranteed free of defects in materials and workmanship for ten years on the frame and five years on the cover. Our guarantee assures you of either a full refund or repair or replacement of the defective materials or workmanship without charge, at the discretion of our Customer Service Department. -
Page 3: Important User Information
Wenger Corporation. Wenger Corporation does not assume any responsibility for any errors that may appear in this manual. In no event will Wenger Corporation be liable for technical or editorial omissions made herein, nor for direct, indirect, special, incidental, or consequential damages resulting from the use or defect of this manual. -
Page 4: Required Tools
1. Remove the Assembly and Owners manual. 2. Remove the two 1 x 4” boards and protective cardboard from each side of the crate assembly. 3. Cut and remove the plastic wrap that encloses the Attic Storage System Assembly. Item... -
Page 5: Assembly
SSEMBLY To begin the assembly of the Attic: 1. Hold a front frame (item 2) weldment with the 3/4" x 1 1/2" tubing horizontal. Some assistance may be required. 2. Position a side frame (item 3) behind the front frame (item 2). (figure A) Note: The offset holes allow the side frame to be flush with the bottom of the front... - Page 6 8. Install the four plastic square plugs (item 5) into the outermost top corners of the front frame tubing weldment. The plugs will protect the Attic Storage System cover when it is being installed. Inspect for burrs or other sharp edges that may damage the cover and remove them with a file if necessary.
-
Page 7: Installation
Measure first to be certain that the width and depth are correct and that the height (30") of the Attic Storage System Storage System will not be obstructed. 11. Position the floor (item 4) 3/4" back from the front edge of the base cabinet. The holes on each end of the floor should be aligned with the center of the cabinet(s) end panels. - Page 8 Repeat as necessary. 18. Open the zippers and tighten the side screws to hold the Attic Storage System assembly in position on top of the cabinet.