Table of Contents
Advertisement
10.
Use a carriage bolt (3/8 x 1 inch) and a locknut
(3/8 inch) to install the stop bracket to the right
side of the machine
to 37 to 45 N∙m (27 to 33 ft-lb).
1. Locknut (3/8 inch)
2. Stop bracket
11.
Remove the hitch pin and cotter pin from the
A-frame and use it to install the hitch receiver
(Figure
14). Ensure that the pin locks the
A-frame to the cross tube.
1. Hitch receiver
2. Hitch pin
12.
Move the blower in front of the machine and lay
the belt underneath the machine so that it is
lined up with the clutch
(Figure
13). Torque the bolt
Figure 13
3. Carriage bolt (3/8 x 1 inch)
Figure 14
3. Cotter pin
(Figure
15).
1. Blower assembly
2. Belt
13.
Place the blower assembly forks onto the
bushing assemblies
g250341
14.
Route the belt to the idler pulley.
Important:
belt contacts the pulley as shown in
17. Use the shoulder bolt as a guide for the
belt.
g230752
10
Figure 15
3. Clutch
(Figure
16).
Figure 16
Ensure that the wide side of the
g230767
g250511
Figure
Advertisement
Table of Contents
