Advertisement
Bottle Preparation
Before preparing a bottle with the Formula Pro:
1
Fill Water Tank to MAX line
with room temperature
purified water.
MAX
Pour powder loosely and evenly into Powder Container. Do not pack powder inside
or overfill Powder Container. Powder can be spread evenly with the 3 arms on the
Powder Container Lid before closing.
About water temperature
The heater in the Water Tank will
warm the water and keep it warm as
long as the machine is powered on.
If you refill the Water Tank with cool
or room temperature water and
need to use the machine right away,
the machine can be used while
water is heating
(flashing yellow light)
.
If you run the machine with cool or
room temperature water, before the
water is warm and ready, always
make sure formula is mixed properly
and check for clumps.
Bottle Preparation continued on next page
5
2
Fill Powder Container
to MAX line with
formula powder.
Temperature Indicator Lights
Solid Green = Water warm and ready.
Flashing Yellow = Water heating.
Flashing Yellow & Green = Water poured
into tank is too hot or too cold.
room temperature or cool water . Flashing green & yellow
lights mean the water poured into in the Water Tank is too
hot or too cold. The machine will not work while the green
& yellow lights flash. If you don't want to wait long for the
water to heat, do not fill with water stored in the refrigerator.
Never fill Water Tank with hot water. If you boil water
before using it in the machine, let the water cool to
body or room temperature before pouring it into the
Water Tank.
Bottle Preparation Continued
3
Select correct height for Drip
Tray based on bottle height.
Lift up and pull out to remove.
Push in and
down
to install.
4
Select bottle size by pressing the ounce
button. With each push, the amount will
increase 2 ounces.
6
7
Machine will dispense
formula into bottle and
stop automatically
when done.
Check level of mixed
formula.
Level will appear higher
due to added powder
volume.
Never remove Water Tank, Funnel or Powder Container while machine is in operation.
After baby stops feeding from bottle, discard any leftover formula mixture.
Always hold the bottle when feeding baby. Never prop the bottle up and leave your baby
to feed unsupervised.
Short Bottle
Tall Bottle
Adjust the drip tray so the bottle is as
close to the Funnel outlet as possible.
This will make sure no formula spills
outside of the bottle.
5
When desired ounce size is selected,
press start to dispense formula.
8
8oz
6oz
Check
4oz
temperature
2oz
of formula...
...and feed baby.
6
Advertisement
