Fuel And Oil Priming; Fuel Requirements - BRP Evinrude E-Tec Series Installation Manual

FUEL AND OIL PRIMING

FUEL REQUIREMENTS

A
WARNING
Gasoline is extremely flammable and
highly explosive under certain conditions.
Improper handling of fuel could result in
property damage, serious injury or death.
Always turn off the outboard before fuel-
ing.
Never permit anyone other than an adult
to refill the fuel tank.
Do not fill the fuel tank all the way to the
top or fuel may overflow when it expands
due to heating by the sun.
Remove portable fuel tanks from the boat
before fueling.
Always wipe off any fuel spillage.
Do not smoke, allow open flames or
sparks, or use electrical devices such as
cellular phones in the vicinity of a fuel leak
or while fueling.
Minimum Octane
Evinrude/Johnson outboards are certified to oper-
ate on unleade d automotive ga soline with an
octane rating equal to or higher than:
87 (R+M)/2 AKI, or
•
90 RON
•
Use unleaded gasolin e tha t co ntains met hyl ter-
tiary b utyl ethe r (MTBE) ONLY if the MTBE con-
tent does not exceed 15% by volume.
Use alcoho l-extended fue ls ONLY if th e alcoh ol
content does not exceed:
10% ethanol by volume
•
5% methanol with 5% cosolvents by volume
•
FUEL AND OIL PRIMING
FUEL REQUIREMENTS
When using alcoho l-extended fue ls, be aware of
the following:
The b oat's fuel system may h ave different
•
requirements regarding the use of alcohol fuels.
Refer to the boat's owner guide.
Alcohol at tracts and ho lds moisture that can
•
cause corrosion of metallic parts in the fuel sys-
tem.
Alcohol blend ed fuel ca n cause engine pe rfor-
•
mance problems.
All parts of the fuel system should be inspected
•
frequently and replaced if signs of deterioratio n
or fuel leakage are found. Inspect at least annu-
ally.
Always use fresh gasoline. Gaso-
IMPORTANT:
line will oxidize, resulting in loss of octane and vol-
atile compounds, as well as the production of gum
and varnish deposits which can damage the out-
board.
Additives
The only fuel additives ap proved
IMPORTANT:
for use in Evinrude outboards are 2+4
tioner a nd Evinrude/Johnson Fue l System
Cleaner. Use of other fuel additives can result
in poor performance or engine damage.
Evinrude/Johnson 2+4 Fuel Conditioner will
help prevent gum and varnish deposits from form-
ing in fue l syste m co mponents and will re move
moisture from the fuel system. It can be used con-
tinuously an d should be use d during any perio d
when the outboard is not being operated on a reg-
ular basis. It s use will reduce sp ark plug fo uling,
fuel system icing, and
deterioration.
Evinrude/Johnson Fuel System Cleaner will
help keep fuel injectors in optimal operating condi-
tion.
fuel condi-
®
fuel system compone nt
75
4