BRP Evinrude E-Tec Series Installation Manual page 58

OUTBOARD RIGGING
EVINRUDE E-TEC 90° V MODELS 200–300 HP
For an I-Command oil level d isplay, an accessory
CANbus oil level sende r must be inst alled in the
oil t ank. Co nnect the sender to the I-Command
network. Refer to the I-Command Digital Net-
work Guide, P/N 355008.
Use Evinrude Diagnostics software to adjust net-
work settings in th e EMM. From the Settings
screen, select Engine Options.
Engine Options Screen
ICON Network Connections
If the outboard is equ ipped for an Evinrude ICON
control system, con nect the outboard to the net-
work as follows.
Refer to Evinrude ICON / I-Command Harness
Connections on p. 14.
Connect the buss cable from the rear network hub
to the outboard's network harness.
1. ICON network connector
56
IMPORTANT:
ing rings. Prop erly aligne d conne ctors a ssemble
easily.
DO NOT use
cable connectors.
To assemble the connectors:
Use the large t abs and small t abs to carefully
•
align buss cable connectors.
Carefully align pins and socket s of conne ctors.
•
Do NOT force connectors together.
Tighten locking rings of buss connectors fing er
•
tight. Do NOT use locking rings to force connec-
tors together.
008563
1. Large tabs
2. Small tabs
Do not rot ate co nnectors un til t hey a lign. This
could result in a mismatched connection. It is pos-
sible for each pin to enter a socket even if the tabs
are misaligned. Look at the t abs to en sure con-
nector alignment prior to making the connection.
Engine Mo nitor information is distributed to
ICON or I-Command network through th e ICON
gateway module. Refer to the I-Command Digital
Network Guide, P/N 355008.
The ICON Harne ss an d Relay Kit, P/N 76529 6,
1
must be used to pro vide power to boat accesso-
ries that requ ire switched B+. This kit is used in
place of connecting accessories to the "A" termi-
nal o f th e key switch. Accessories connected to
the accessory power rela y sho uld not exceed 7
amps.
NOTICE
Do not connect boat accessories to
008001
the key switch of an ICON system. Connecting
accessories to the key switch can cause low
Do not force conn ectors or lock-
Electrical Grease on ICON buss
1
2
007883
an