BRP Evinrude E-Tec Series Installation Manual page 75

SystemCheck Harness
Connections
Before installing electrical connectors, check t hat
the seal is in place. Cl ean off any dirt from con-
nectors. Apply a light coat of Electrical Grease to
the seal only. DO NOT fill connectors with Electri-
cal Grease.
1. Seal
Route ele ctrical harness a long the ed ge of the
lower engine cover.
1
1. Key switch connector
2. Tachometer connector
Secure connectors to lower motor cover with two
tie straps as shown.
2
1. Wire routing
2. Secure with two tie straps
EVINRUDE E-TEC MODELS 15–30 HP
Route trim and tilt connector under air silence r.
Use tie strap to secure connector as shown.
1. Trim and tilt connector
1
Install battery cables and secure with tie strap.
42079A
1
2
1. Tie strap
Route bat tery cab le throug h grommet of
lower motor cover.
007263
1
1. Battery cable grommet
NOTICE
BE SURE all harnesses and wires
are not pinched, cannot contact flywheel, and
007125
do not interfere with moving throttle or shift
linkages.
OUTBOARD RIGGING
007264
2
007240
port
1
008009
73
1
3