Smart Mode - Hisense L1-04 Instructions Manual

Operation instructions

SMART mode(

SMART mode( invalid for multi system invalid for multi system
How to set SMART mode?
SMART
Press the button.
Result : Enters SMART mode(fuzzy logic operation)
directly regardless of the unit is on or off.
Temperature and fan speed are automatically
set based on theactual room temperature.
Heat pump models
Indoor temperature
21℃ or below
21℃-23℃
23℃-26℃
Over 26℃
Cooling only models
Indoor temperature
23℃ or below
23℃-26℃
Over 26℃
SMART button is ineffective in SUPER mode.
Press MODE button cancel SMATR mode.
Note: Temperature, airflow and direction are controlled automatically in SMART mode.
However, for the inverter you can choose from -7 to 7. if you still feel uncomfortable.
What you can do in SMART mode?
Your feeling
Uncomfortable because
of unsuitable air flow
volume.
Uncomfortable because
of unsuitable flow
direction.
How to cancel the SMART mode?
MODE
Press the button.
Result : The SMART mode will be cancelled.
) )
Operation mode
HEATING
FAN ONLY
DRY
COOLING
Operation mode
FAN ONLY
DRY
COOLING
Button
Indoor fan speed alternates among Higher, High,
Medium, low and Lower each time when this button
FAN SPEED
is pressed.
Press it once, the vertical adjustment louver(horizontal
adjustment louver) swings to change vertical airflow
direction(horizontal airflow direction). Press it again,
the swing stops.
5
SMART
PRESS
TEMP.
Target temperature
22℃
Room temperature
decrease 2℃ after
operate for 3 minutes
26℃
Target temperature
Room temperature
decrease 2℃ after
operate for 3 minutes
26℃
Adjust
SMART
TEMP.
MODE
MODE
PRESS