Table of Contents
Advertisement
408
7-2. Steps to take in an emergency
NOTICE
When installing the cover in the cen-
■
ter of the rear seat
Make sure that the seat belts are not
caught in the cover. Failure to do so may
cause damage to the cover installation
clip and make it impossible to install the
cover.
Opening the glove box
The glove box can be opened by per-
forming the following operations after
unlocking the doors.
If the glove box is locked, unlock it with the
mechanical key. (P.302)
1
Remove the cover using a flathead
screwdriver.
To prevent damage to the cover, cover the
tip of the screwdriver with a rag.
2
Push the flathead screwdriver into
the part shown in the illustration to
open the glove box.
After opening the glove box
■
The glove box can be opened normally by
closing the glove box after restarting the
engine <hybrid system>.
Restarting the engine <hybrid
system>
If you have a set of jumper (or booster)
cables and a second vehicle with a 12-
volt battery, you can jump start your
vehicle using the following procedure.
1
Confirm that the electronic key
(including the card key) is being
carried.
When connecting the jumper (or booster)
cables, depending on the situation, the
alarm may activate and doors locked.
(P.84)
Advertisement
Table of Contents
