Table of Contents
Advertisement
*1
: When the set speed is shown in "km/h"
*2
: When the set speed is shown in "MPH"
Changing the vehicle-to-vehicle
distance (vehicle-to-vehicle dis-
tance control mode)
Pressing the switch changes the vehi-
cle-to-vehicle distance as follows:
1
Long
2
Medium
3
Short
The vehicle-to-vehicle distance is set auto-
matically to long mode when the engine
switch <power switch> is turned to IGNI-
TION ON mode <ON mode>.
If a vehicle is running ahead of you, the pre-
A
ceding vehicle mark
will also be dis-
played.
Vehicle-to-vehicle distance set-
tings (vehicle-to-vehicle dis-
tance control mode)
Select a distance from the table below.
Note that the distances shown corre-
spond to a vehicle speed of 80 km/h
(50 mph). Vehicle-to-vehicle distance
increases/decreases in accordance
with vehicle speed. When the vehicle is
4-5. Using the driving support systems
stopped by system control, the vehicle
stops at a certain vehicle-to-vehicle
distance depending on the situation.
Distance options
Long
Medium
Short
Resuming follow-up cruising
when the vehicle has been
stopped by system control (vehi-
cle-to-vehicle distance control
mode)
After the vehicle ahead of you starts
off, press the "+RES" switch.
Your vehicle will also resume follow-up
cruising if the accelerator pedal is
depressed after the vehicle ahead of
you starts off.
235
Vehicle-to-vehicle
distance
Approximately 50
m (160 ft.)
Approximately 40
m (130 ft.)
Approximately 30
m (100 ft.)
4
Advertisement
Table of Contents
