Table of Contents
Advertisement
138
3-3. Adjusting the seats
will be overwritten.
■
Seat positions that can be memorized
(P.135)
The adjusted positions other than the posi-
tion adjusted by lumbar support switch can
be recorded.
■
In order to correctly use the driving
position memory function
If a seat position is already in the furthest
possible position and the seat is operated in
the same direction, the recorded position
may be slightly different when it is recalled.
WARNING
Seat adjustment caution
■
Take care during seat adjustment so that
the seat does not strike the rear passen-
ger or squeeze your body against the
steering wheel.
Recalling a driving position
1
Turn the engine switch <power
switch> to IGNITION ON mode
<ON mode>.
2
Check that the shift position is in P.
3
Press one of the buttons for the
driving position you want to recall
until the buzzer sounds.
To stop the position recall operation
■
part-way through
Perform any of the following:
●
Press the "SET" button.
●
Press button "1", "2" or "3".
●
Operate any of the seat adjustment
switches (only cancels seat position
recall).
●
Operate the tilt and telescopic steering
control switch (only cancels steering
wheel position recall).
Operating the driving position memory
■
after turning the engine switch <power
switch> off
Recorded seat positions can be activated
up to 180 seconds after the driver's door is
opened and another 60 seconds after it is
closed again.
Registering/canceling/recalling
a driving position to an elec-
tronic key (including a card key)
(memory recall function)
Registering procedure
■
Record your driving position to button
"1", "2" or "3" before performing the
following:
Advertisement
Table of Contents
