TP-Link CPE605 Installation Manual page 5

• Panel Layout
• Passive PoE Adapter
Remote Reset
Press and hold for about 5 seconds to reset
the CPE to its factory defaults.
On: The wireless function is enabled.
On: A device is connected to the ETHERNET port,
but there is no activity.
Flashing: A device is connected to the
ETHERNET port and is active.
On: The CPE is powered on.
RESET
Press and hold for 5 seconds to reset the CPE to
its factory defaults.
ETHERNET
The port is used to connect to the POE port of
the provided PoE adapter for both data
transmission and power supply through Ethernet
cabling.
Power LED
On: The CPE is powered on.
Off: The CPE is powered off.
03