Dynajet Power Commander V Installation Instructions

2009 yamaha vmax

Advertisement

Quick Links

2009 Yamaha VMax
i n s t a l l a t i o n i n s t r u c t i o n s
PLease read aLL directions before starting instaLLation
22-003 www.powercommander.com
2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com

Parts List

1
Power Commander
1
USB Cable
1
CD-ROM
1
Installation Guide
2
Power Commander Decals
2
Dynojet Decals
1
O2 controller
2
Velcro
1
Alcohol swab
the ignition MUst be tUrned
off before instaLLation!
You Can also download the
Power CoMMander software and
latest MaPs froM our web site at:
www.powercommander.com
2009 Yamaha VMax PCV - 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Power Commander V and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Dynajet Power Commander V

  • Page 1 Parts List Power Commander USB Cable CD-ROM 2009 Yamaha VMax Installation Guide i n s t a l l a t i o n i n s t r u c t i o n s Power Commander Decals Dynojet Decals O2 controller Velcro Alcohol swab...
  • Page 2 POWER COMMANDER V INPUT ACCESSORY GUIDE ACCESSORY INPUTS Map - The PCV has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use Usb connection any open/close type switch.
  • Page 3 fig.a Remove Remove the main seat. Remove the cosmetic air box cover and side panel (Fig. A). fig.b Lay the PCV under the right hand side cover temporarily. Route the PCV harness inside of the subframe and go up towards the battery (Fig.
  • Page 4 fig.d Plug the connectors from the PCV in-line of the stock wiring harness and throttle bodies (Fig. D) fig.e Using the supplied Posi-tap attach the GREY wire of the PCV harness to the WHITE wire of the small ECU plug (Fig. E). This is pin #5 fig.f PCV ground...
  • Page 5 fig.g Using the supplied velcro secure the PCV to the plastic cover under the right hand side cover (Fig. G). Mount the PCV behind the stock electronics fig.h Locate the O2 sensor connection under the rubber boot on the right hand side of the bike (Fig.

Table of Contents