Maintenance - DeWalt DW060 Instructions Manual

Squaring wall cutouts and fi xtures (fi g. D3)
• Position the tool against the wall in one of the lower corners.
• Align the intersection point of the laser lines (8) with the corner.
• Level the tool as required.
• Proceed as described above.
Setting intermediate angles (fi g. E)
The tool allows intermediate angles at 22.5°, 45° and 67.5°.
• Align the laser line of either one of the laser beams with the position
mark or reference point.
• Mark the intersection point of the laser lines (8).
• Mark the desired angle on the surface using the scale (4).
• Whilst keeping the intersection point over the marking (8), rotate the tool
until the laser line aligns with the angle marking as measured from the
scale.
Tool aids
Several aids have been supplied that might be helpful while operating the tool.
Target card (fi g. F)
The target card locates and marks the laser beam as the beam crosses
the card, thus enhancing the visibility of the projected line. The laser beam
passes through the red plastic surface and is refl ected by the refl ective rear
side of the card. Supporting easy use during horizontal adjustment, the
card is marked with inch and metric scales, and has a stand at the back to
place it on the fl oor.
Optional accessories
Consult your dealer for further information on the appropriate accessories.

MAINTENANCE

Your D WALT power tool has been designed to operate over a long period
E
of time with a minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
E N G L I S H
39