DeWalt DW071 Instructions Manual page 29

5 Use appropriate tool
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool.
The tool will do the job better and safer at the
rate for which it was intended.
Warning! The use of any accessory or attachment
or performance of any operation with this tool,
other than those recommended in this instruction
manual may present a risk of personal injury.
6 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance.
Follow the instructions for maintenance and
changing accessories. Inspect the tool cords at
regular intervals and, if damaged, have them
repaired by an authorized D
Keep all controls dry, clean and free from oil and
grease.
7 Store idle tools
When not in use, power tools must be stored in a
dry place and locked up securely, out of reach of
children.
8 Check for damaged parts
Before using the tool, carefully check it for damage
to ensure that it will operate properly and perform
its intended function. Check for misalignment
and seizure of moving parts, breakage of parts
and any other conditions that may affect its
operation. Have damaged guards or other
defective parts repaired or replaced as instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
D WALT repair agent.
E
9 Remove the batteries
Remove the batteries when not in use, before
servicing and when changing accessories.
10 Have your tool repaired by an authorized
D WALT repair agent
E
This power tool is in accordance with the relevant
safety regulations. To avoid danger, electric
appliances must only be repaired by qualified
technicians.
Additional safety instructions for rotary lasers
• This laser complies with class 2 according to
EN 60825-1:1994+A11. Do not replace a laser
diode with a different type. If damaged, have the
laser repaired by an authorised repair agent.
WALT repair agent.
E
• Do not use the laser for any purpose other than
projecting laser lines.
An exposure of the eye to the beam of a class 2 laser
is considered safe for a maximum of 0.25 seconds.
Eyelid reflexes will normally provide adequate
protection. At distances over 1 m, the laser complies
with class 1 and thus is considered completely safe.
• Never look into the laser beam directly and
intentionally.
• Do not use optical tools to view the laser beam.
• Do not set up the tool at a position where the
laser beam can cross any person at head height.
• Do not let children come in contact with the laser.
Additional safety instructions for batteries
• Do not open or mutilate batteries for any reason.
• Do not expose batteries to water.
• Do not expose batteries to fire.
• Do not store batteries in locations where the
temperature may exceed 40 °C.
• Use only the correct size of batteries.
When replacing, do not mix old batteries with
new ones.
• Under extreme conditions, battery leakage may
occur. When you notice liquid leaking out,
proceed as follows:
- Carefully wipe the liquid off using a cloth. Avoid
skin or eye contact. Do not swallow.
- In case of skin or eye contact, rinse the liquid
off with clean flowing water for at least 10
minutes and contact a doctor.
Avoid short- circuiting the contacts of a
removed battery.
Labels on tool
For a complete reproduction of the labels attached
to the tool, refer to the summary in the back of the
manual. The labels on the tool show the following
pictographs:
Read instruction manual before use
Laser warning
Bump warning
E N G L I S H
29