Explanatory Photos for DISASSEMBLY
• For the shooting direction of each photos used in this manual, see the photo below.
• A, B, C and D in the photo below indicate the shooting directions of photos.
• The photographs with no shooting direction indicated were taken from the top of the unit.
• Photos of AVR-S950H E3 are used in this manual.
The viewpoint of each photograph
(Shooting direction : X) [View from the top]
↓Shooting direction: B↓
↑Shooting direction: A↑
Attention :
When reinserting the Antenna Cable after it has been disconnected, make sure it is facing the direction
shown in Ⓐ above.
1. FRONT PANEL ASSY
Proceeding :
(1) Remove the screws.
(2) R emove the screws. Cut the wire clamp, then remove the CORD HOLDER and connector.
�
69
TOP COVER
→
FRONT PANEL ASSY
View from the bottom
Remove the TAPE. Remove the FFC.
CP4400
x2
CORD HOLDER
FFC
N1008
↑Shooting direction: A↑
x7
CUT
TAPE
N1000