Advertisement
Quick Links
Advertisement
Related Manuals for Pablo CLAMP
Summary of Contents for Pablo CLAMP
- Page 1 CLAMP ASSEMBLY & INSTALLATION INSTRUCTIONS pg. 1...
- Page 2 CLAMP INSTALLATION ALIGN THE FRONT SURFACE OF THE CLAMP TO THE EDGE OF THE TABLE SLIDE CLAMP FORWARD UNTIL THE EDGE OF TABLE MEETS POST NOTE: CLAMP CAN ONLY BE APPLIED TO SURFACES UP TO 3” THICK LOCKING 3MM HEX KEY...
- Page 3 CLAMP ASSEMBLY PLUG TYPES: SLIDE ARM ONTO STEM 1. SLIDE PLUG INTO POWER SUPPLY 2. ALIGN CONNECTOR/POWER SUPPLY LOCKING FEATURES 3. INSERT CONNECTOR POWER 4. TURN CONNECTOR 90 DEGREES SUPPLY TO LOCK LOCK CONNECTOR LOCK A. N AMERICA B. UK C.
- Page 4 CLAMP FS ASSEMBLY & INSTALLATION INSTRUCTIONS pg. 1...
- Page 5 CLAMP FS ASSEMBLY REMOVE BASE FROM PACKAGING AND PLACE VERTICALLY IN BOX SLOT AS SHOWN TO ASSIST WITH ASSEMBLY PROCEDURE BOX SLOT SLIDE BOTTOM OF CLAMP LAMP INTO BASE CAVITY AS SHOWN REMOVE EXISTING TOP CLAMP FROM STEM pg. 2...
- Page 6 CLAMP FS ASSEMBLY SECURE CLAMP LAMP INTO BASE WITH SUPPLIED WASHERS AND SCREWS 2X SCREWS AND WASHERS PLUG TYPES: SLIDE ARM ONTO STEM 1. SLIDE PLUG INTO POWER SUPPLY 2. ALIGN CONNECTOR/POWER SUPPLY LOCKING FEATURES 3. INSERT CONNECTOR POWER 4. TURN CONNECTOR 90 DEGREES...
- Page 7 CLAMP FS ADJUSTMENT LIFT ARM TO ADJUST HEIGHT AND ROTATE LIGHT SOURCE TO DESIRED POSITION INFO@PABLODESIGNS.COM 888 MARIN STREET SAN FRANCISCO, CA 94124 PABLODESIGNS.COM pg. 4...
- Page 8 CLAMP MINI ASSEMBLY & INSTALLATION INSTRUCTIONS pg. 1...
- Page 9 CLAMP MINI ASSEMBLY ORIENTATION STICKER MAKE SURE THAT ARROW ON ORIENTATION STICKER IS POINTING TO FRONT OF BASE. REMOVE STICKER. INSERT POST INTO BASE AS SHOWN INSERT PROVIDED SCREW INTO HOLE IN BACK OF BASE. USING HEX KEY SUPPLIED, TIGHTEN UNTIL POST IS SECURE.
- Page 10 CLAMP MINI ASSEMBLY PLUG TYPES: 1. SLIDE PLUG INTO POWER SUPPLY SLIDE ARM ONTO POST 2. ALIGN CONNECTOR/POWER SUPPLY LOCKING FEATURES 3. INSERT CONNECTOR POWER 4. TURN CONNECTOR 90 DEGREES SUPPLY TO LOCK LOCK CONNECTOR LOCK A. N AMERICA B. UK C.
- Page 11 CLAMP FLOOR ASSEMBLY & INSTALLATION INSTRUCTIONS pg. 1...
- Page 12 CLAMP FLOOR ASSEMBLY ASSEMBLE BASE BY JOINING TOP LEG TO BOTTOM LEG AS SHOWN SLIDE BOTTOM POST INTO HOLE ON TOP OF BASE USE SUPPLIED HEX KEY TO SECURE BOTTOM POST WITH WASHER AND SCREW PROVIDED. TIGHTEN UNTIL POST IS SECURE BUT CAN STILL ROTATE.
- Page 13 CLAMP FLOOR ASSEMBLY ORIENTATION STICKER SCREW TOP POST INTO ROTATE POST ASSEMBLY SO THAT ARROW ON BOTTOM POST ORIENTATION STICKER IS CENTERED BETWEEN LEGS. REMOVE STICKER. USE HEX KEY TO FIRMLY TIGHTEN POST IN BASE pg. 3...
- Page 14 CLAMP FLOOR ASSEMBLY SLIDE ARM ONTO POST PLUG TYPES: 1. SLIDE PLUG INTO POWER SUPPLY 2. ALIGN CONNECTOR/POWER SUPPLY LOCKING FEATURES 3. INSERT CONNECTOR POWER 4. TURN CONNECTOR 90 DEGREES SUPPLY TO LOCK LOCK CONNECTOR LOCK A. N AMERICA B. UK C.