Adjustment Of Parameters - APRI FBSN-4SD Manual

Place the control device onto the suitable place in the cabin and join cable. Conduct this cable between
control device and control unit and mount the contacts of opposite cable side into the cable box:
Brown conductor
Red-yellow conductor
White-blue conductor
Place control unit on suitable place in a boot and join cable box of rear cable harness.

Adjustment of parameters

1. Short press
(this features do not require switching power off and on, activates automatically after short delay)
Right button Disable:
Left button Mute:
2. Long press (after 10
After few clicks, less then 10 system returns into operation without any change:
Both buttons FS
One of buttons, not care which one setting mode entry
Short press parameter selection
Parameters
(values defined for parameters not standard for EPS4006, FS values are the same as for EPS4006)
1
4
5
8
9
10
13
14
Long press display of selected parameter value
Short press
Right button
Left button
Long press
one of buttons, not care which one
Power off enables usage of sonar with new setup
pos.1
pos.6
pos.13
line around the car disappears, ON/OFF headline shines
Sonar is quiet and does not show situation behind the vehicle
if previously disabled enables sonar.
Sonar is quiet but shows situation behind the vehicle
if previously muted turns the speaker back ON
th
click)
resetting of Factory setting
Acoustic unit selection/ volume turn off
0 volume turned off
1 low volume piezo beeper selected as acoustic output
2 high volume piezo beeper selected as acoustic output
3 low volume rear speaker selected as acoustic output
4 high volume rear speaker selected as acoustic output (FS)
Range of central sensors
Range of corner sensors
STOP zone of central sensors
STOP zone of corner sensors
Suppression of spare wheel indication
Delay of rear sensors activation ; 1 = automatic gearbox
Numbering direction (all possible combinations)
0 standard installations (FS)
1 opposite numbering direction to standard
increasing value in preset steps
decreasing value in preset steps
saves value and returns into parameter selection state
saving assigned by beep and shine of red led