Philips LTC 2810/90 Instructions For Use Manual page 8

2.2 Rear Panel
9
Video A terminals [VIDEO A IN/OUT]
Video signal input (IN) and output (OUT) terminals
The output terminal is bridge-connected (auto
termination).
IN : Video signal input terminal
OUT : Bridge-connected video signal output terminal
NOTE: For corresponding audio signals, use the AUDIO A
11
terminals .
10
Video B terminals [VIDEO B IN/OUT]
Video signal input (IN) and output (OUT) terminals.
The output terminal is bridge-connected (auto
termination).
IN : Video signal input terminal
OUT : Bridge-connected video signal output terminal
NOTE: For corresponding audio signals, use the AUDIO B
11
terminals .
Rear panel
11
Audio A, B terminals [AUDIO A, B IN/OUT]
Audio signal input (IN) and output (OUT) terminals. The
output terminal is bridge-connected.
IN : Audio signal input terminal
OUT : Bridge-connected audio signal output terminal
NOTE: For corresponding video signals, use the VIDEO
9 10
terminals , .
12
AC Inlet
Power input connector. Connects the supplied AC power
cord to the appropriate AC outlet.
Note:
The impedance is automatically set to 75
a signal on the input connector while operating in a single
connection mode. However, if a cable is connected to the
output connector, the connection is placed into the open
status by the multiple connection and high impedance
automatically selected. Do not leave an unused cable
connected to the monitor. If a single cable is used, then it
must be connected to the input connector for the 75
auto termination selector to function properly.
1.4
by the input of