Codyson CD-4820 User Manual page 12

This machine has a circuit protecting it when over heat. When the right red indication light
is on, it means this circuit works. If pressing ON, the time left will be displayed but there is
no ultrasonic wave. The machine needs to stop working for 15 minutes, then pressing ON
and the right green light is on, the machine can work normally.
Red
10
Press "ON" button to start cleaning while the right green
3
indication light is on.
During cleaning, you can hear the "BUZZ" voice,
it means the unit is working .
When the timer counts down "
tically stop. If required you can stop / pause the cleaning
Green
process at any time by pressing the OFF button, pressing
the ON button again will resume the cleaning and the
Red
countdown will continue. When cleaning has finished,
you can repeat the process by pressing ON button again.
Using the HEATER function.
4
Pressing the TC button starts the built in heater. The
red LED on the left of the control panel will illuminate.
The water will heat to a maximum of 65 degrees C.
Please refer to the
cleaning for details.
If required, you can stop / pause the cleaning process at
any time by pressing the OFF button, pressing ON again
will resume the cleaning and the countdown will continue.
The program can be reset at any time by pressing the SET
button.
5
When cleaning is finished, unplug it and open the lid,
then take out the item. At last, pour away the water
from stainless steel tank and wipe it up.
000
", the unit will automa-
2
point of four different ways of