Dremel Lite 7760 Operating/Safety Instructions Manual page 27

1600A01A91.qxp_7760 3/4/19 1:55 PM Page 27
EZ Drum™ Mandrel No. EZ407SA has a
spring loaded sleeve and is used with
sanding bands.
disconnect the plug from the power source
or the battery pack from the tool before
changing accessories. Such preventative
safety measures reduce the risk of starting
the power tool accidentally.
Always make sure accessory is properly
seated on mandrel before use. Incorrect
seating of accessory on mandrel may lead to
personal injury or property damage.
To load accessory:
1. As indicated,
underneath the mandrel and pull firmly
up. This will place the EZ Drum™ in the
"unlocked" position (Fig. 1).
2. Keeping two fingers beneath the mandrel,
slide the sanding band down until the
entire blue mandrel is covered (Fig. 2).
3. To return to "locked" position, press
firmly down on the top of the mandrel
(Fig. 3).
Removing the sanding band on
the mandrel:
1. Place two fingers underneath the mandrel
and pull firmly up. This will place the EZ
Drum™ in the "unlocked" position (Fig. 1).
2. Sanding band will now easily slide off
mandrel (Fig. 2). Do not squeeze sanding
band when removing from EZ Drum™
mandrel. This can lead to rubber band
pulling off mandrel and becoming
inoperable.
EZ Drum™ Operating Instructions
Always make sure the
rotary tool is "OFF" and
place two fingers
Fig. 1
Fig. 2
Fig. 3
27