Beko WMY 91483 LB3 User Manual page 21

4.3.10 Loading door lock
There is a locking system on the loading door of the product that prevents opening of the door in cases when
the water level is unsuitable.
"Door Locked" light in the panel turns on when the loading door is locked.
4.3.11 Changing the selections after programme has started
After the programme has started you can make the following changes.
Switching the product to pause mode
Press the Start/Pause button to switch the machine to pause mode while a programme is running. The light
of the step which the machine is in starts flashing in the Programme Follow-up indicator to show that the
machine has been switched to the pause mode. Also loading door light blinks until the door is ready to be
opened. When the loading door is ready to be opened Loading Door light will turn off, programme step light
will continue to flash.
Changing the auxiliary function, speed and temperature
Depending on the step the programme has reached, you can cancel or select the auxiliary functions. See
"Auxiliary function selection".
Also you can change temperature and cycle adjustments. See "Temperature selection" and "Spin speed
selection".
C
If no change is allowed, the relevant light will flash 3 times.
Adding or taking out laundry
1. Press the Start / Pause button to switch the product to pause mode. The programme follow-up light of the
relevant step during which the machine was switched into the pause mode will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out the laundry.
4. Close the Loading Door.
5. Make changes in auxiliary functions, temperature and speed settings if necessary.
6. Press Start / Pause to operate the product.
4.3.12 Cancelling the programme
The programme is cancelled when the product is turned off and on again. Press and hold On / Off button for
3 seconds.
C
If you press On / Off button when the Child Lock is enabled, the programme will not be cancelled. You should cancel the
Child Lock first.
If you want to open the loading door after you have cancelled the programme but it is not possible to open the loading
door since the water level in the product is above the loading door opening, then turn the Programme Selection knob to
Pump+Spin programme and discharge the water in the product.
4.3.13 End of programme
The "Complete" light (LED) will turn on when the programme is over.
If you do not press any button for 10 minutes, the product will turn off automatically. Display and all indicators
are turned off.
Completed programme steps will be displayed if you On / Off.
4.3.14 Energy saving mode
If no action is taken for 2 minutes after turning on the product with On / Off button or after the chosen
programme ends, the product will switch to energy saving mode automatically. The brightness of the indicator
lights will decrease. This display will be closed completely if programme time display is available.
If you turn the programme knob or touch any button, the lights will switch back to previous position.
C
This is a feature of this product, and not an error.
Washing Machine / User's Manual
21 / EN