Advertisement
In the "Communications" tab you may choose to "Connect" to an ECI-60 or
configure your "Communications Settings" When changing communications set-
tings, the ECI-60 must not be connected to the setup software.
Selecting "Communications Settings" presents you with the above window in
which you may configure your communications settings appropriately with "Com1"
through "Com9" and TCP/IP if your access to the ECI-60 is through a network.
ECI-60 IP Retrieval.
The RS232 port can be used to retrieve the ECI-60 IP assignment and built in
test status. When the unit is power on, the test results and settings are sent to
the RS232 port. With a terminal application the data sent can be viewed. A com-
mon terminal application is Hyper Terminal that can be configured to receive
data from a RS232 port. This port will require the following settings: 38400 bit
per second, 8 bit data, 1 stop bit, no-parity, and handshake is none.
- 10 -
Advertisement
