Table of Contents
Advertisement
ENGINE: CRANKSHAFT AND MAIN BEARINGS
51
Fig. 79 - Tightening main bearing cap screws.
1. Torque wrench.• 2. Main bearing cap.
The installation of flywheel end oil seal is facili-
tated through the use of tool A. 60281 (fig. 81) which
allows (or the correct placement of cover to the
flywheel mounting flange on crankshaft.
This
way any risk of oil leakage from distortion
of cover
will
be definitely eliminated.
Clutch Shaft Pilot Bushing.
An oilless-type bronze bushing for clutch
support is press fitted into crankshaft end.
shalt
Fig. 8f • Installing crankshaft front seal cover,
t.
Inserter A. 60'2:81. - 2. Crankshaft front seal cover.• 3. Oil seal.
If
pilot bushing
turns
out to be too much worn,
renew it.
Do not rework the interior of the bushing in
place.
To take out the bushing use ram puller A. 40006/1
in conjunction with item A. 40006/2 (fig. 82).
Fig. 80 • Checking crankshaft end play.
1. Magnetic dial Indicator.
Fig. 82 • Pulling clutch shaft pilot bushing.
1. Clutch shaft pilot bushing. - 2. Adapllng Item A. 40006/2. - 3. Ram
puller A. 40006/1.
Advertisement
Table of Contents
