Assembly And Adjustments; Prior To Operation - DeWalt D26676 Original Instructions Manual

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the switch is in the OFF position. An
accidental start-up can cause injury.
Adjusting the Depth of Cut (fi g. 2)
Turn the planing depth adjustment knob (d).
One revolution of the adjustment knob equals
a 1.5 mm change in depth. One graduation
corresponds to a depth of cut of 0.1 mm, and this is
offered up to 1.0 mm in depth.
Attaching and Removing the Parallel
Fence (fi g. 1, 3)
The parallel fence (l) is used for optimum tool control
on narrow workpieces.
1. Loosen the parallel fence tightening bolt (f).
2. Fit the parallel fence (l) in the hole (g) on either
side.
3. Tighten the parallel fence tightening bolt.
4. To remove the parallel fence, proceed in reverse
order.
Cutters
WARNING: Always replace both
cutters.
TO REMOVE CUTTER (FIG. 4)
1. Loosen and remove the three screws (m) with
the wrench (n) provided.
2. Remove the drum cover (q) from the drum (u).
3. Carefully remove the cutter/guide bar assembly
[two screws (t), guide bar (s) and cutter (o)].
4. Adjust, sharpen or replace cutter.
TO ADJUST CUTTER USING GAUGE (PROVIDED WITH
TOOL) (FIG. 5)
1. Place the cutter/guide bar assembly [two
screws (t), guide bar (s) and cutter (o)] on the
gauge plate (r) with the cutting edge of the
cutter flush against the gauge plate inside wall.
The heel of the guide bar (s) will overlap the end
of the gauge plate (r).
2. Loosen the screws (t) with the wrench provided.
3. Simultaneously push the cutter (o) and the guide
bar (s) into the gauge plate inside wall, making
sure that the cutter is held fi rmly against the
gauge plate inside wall and securely tighten
screws (t).
SHARPENING CUTTERS (FIG. 6)
1. Fasten the cutter to sharpening holder (v).
Be sure both cutter edges face in the same
direction.
2. Place the cutter edges so that they rest flat on
the grinding stone (not included).
3. Firmly grip the sharpening holder and move
back and forward to sharpen the cutter (o).
TO REINSTALL CUTTER (FIG. 5)
1. Cautiously remove the adjusted cutter/guide
bar assembly [two screws (t), guide bar (s) and
cutter (o)] from the gauge plate (r) and place the
heel of the guide bar (s) into the groove in the
drum (u).
2. Set the drum cover (q) over the adjusted cutter/
guide bar assembly and securely tighten the
three screws (m) to the drum.
3. Repeat procedure for the other cutter.
OPERATION
Instructions for Use
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Use sharp cutters only.

Prior to Operation

• Adjust the depth of cut.
• If necessary, fit and adjust the parallel fence.
Proper Hand Position (fi g. 1)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the
main handle and the other hand on planing depth
adjustment knob (d).
EN GL IS H
7