Table of Contents
Advertisement
EN
10
Troubleshooting
Problem
Tip
•
Interference in the
image on TV2
•
•
•
The video sources
do not respond to
•
the remote con-
trol commands
•
from TV2
•
•
The image of the
video source dis-
appears on TV2
•
•
Buzzing sound
when you use the
remote control.
•
•
Black and white
image with S-VHS
VCR.
Slightly change the position of the
receiver (B) or the transmitter (A).
Change the wireless channel that
is used for communication. See
page 7.
The receiver (B) is out of range of
the transmitter (A). The number
of walls and ceilings in between
the receiver (B) and transmitter
(A) restrict the distance.
Point the remote control directly
to the receiver (B).
Replace the batteries of the
remote controls with new ones.
Install the remote control blaster
cord (E). See page 6.
The maximum operating distance
of the remote control is 5 m.
Turn off the auto standby mode
of the video source. See its user
manual.
Follow the instructions to recon-
nect the video sources. See the
quick start guide.
Slightly change the position of the
receiver or the transmitter until
the buzzing sound stops.
Sometimes it is not possible to
solve the problem.
Check if the SCART connector of
the S-VHS VCR gives signal in
CVBS. See its user manual.
Advertisement
Table of Contents
