Refreshing Carpets - Vax Hard Floor Ultimate User Manual

S3S-U series UG - 15.08.13_User guide 29/08/2013 10:15 Page 7
Operation
To clean with steam detergent
Wood Tile Vinyl

Refreshing carpets

IMPORTANT: When using on carpets, always ensure the velcro microfibre cleaning pad is properly attached
to the floor head.
Place unit into carpet
glider with pad attached.
Move the steam mop slowly
backwards and forwards
across the floor paying
particular attention to high
traffic areas.
vax.co.uk
This product can be used with or without detergent and on different
floor surfaces. To use with detergent use the surface selector up and
Carpet
down buttons to cloose desired setting for area you want to clean.
These settings are wood, tile, vinyl and carpet. Squeeze/release trigger
to dispense detergent. To use on carpet or to use your unit WITHOUT
detergent, select 'Carpet.'
WARNING: Only use recommended Vax Steam Detergent.
NOTE: The detergent can be used on hard floor surfaces.
Wood Tile Vinyl Carpet
Turn the dial on the front
of your unit to 'Carpet'
setting.
Refreshing carpets
Place foot on outer
floorhead and gently pull
away main body to
remove the compact
scrub brush.
To recline the unit place
foot on floor head and tilt
handle backwards.
Move steam mop back and
forwards across the floor,
getting into corners and
awkward places.
To produce steam squeeze
the trigger in short bursts
to prevent overly wetting
carpets. Do not hold
down continuously.
7