Package Contents; Assembly And Adjustments - DeWalt D25301D Original Instructions Manual

EN GLI SH
• Do not use to pick up flammable or combustible
liquids, such as gasoline, or use in areas where
they may be present.

Package Contents

The package contains:
1 Dust extraction telescoping system:
1 Side handle
1 Side handle diameter reduction adapter
1 Dust extraction head/dust brush
1 Telescope with depth adjustment slide
1 Dust hose
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Telescope
b. Dust hose
c. Length adjustment button
d. Depth adjustment button
e. Dust extraction head
f. Dust brush
g. Side handle
h. Adapter
INTENDED USE
The D25301D dust extraction telescope has been
designed for the extraction of dust in professional
hammerdrilling in masonry or concrete, and with
solid drill bits mounted to the power tool. DO NOT
use for drilling plastic, wood or metal.
This dust extraction telescope system will fit most
D WALT cordless and corded SDS Plus
E
For more information about D
compatible with this attachment, please contact
your local dealer, refer to the addresses at the back
of the manual or visit www.dewalt.eu.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
16
The dust extraction telescope system is an
attachment for use with professional power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.

ASSEMBLY AND ADJUSTMENTS

Attaching and Removing the
Telescope and Side Handle
TO ATTACH THE TELESCOPE AND SIDE HANDLE (FIG. 1–3)
1. Remove the drill bit, side handle and the depth
2. If the nose of the tool (i) is less than 43 mm, the
3. Align dust extraction telescope (a) with the
4. Insert the dust hose (b) into the dust extraction
TO REMOVE THE TELESCOPE AND SIDE HANDLE
1. To remove the telescope, press the spring-
®
tools.
WALT power tools
E
2. Turn side handle (g) to loosen and slide from
3. If adapter (h) was used, open and remove
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack or
power source before making any
adjustments or removing/installing
attachments or accessories. An
accidental start-up can cause injury.
adjustment rod, if attached to the tool.
adapter is needed to assemble the side handle.
IF ADAPTER IS NEEDED
a. Open supplied adapter (h) and close onto
nose of tool (i).
NOTE: Adapter will slide back and forth on
the tool.
b. Place open end of supplied side handle (g)
onto adapter and turn side handle until tight.
IF ADAPTER IS NOT NEEDED
Place open end of supplied side handle onto
nose of tool and turn side handle until tight.
side handle and then push the dust extraction
telescope against the side handle until the
spring-loaded button (j) locks the dust extraction
telescope into place.
telescope and a vacuum (not included) as
shown in figure 3.
loaded button (j) and remove the telescope.
nose of tool.
adapter from nose of tool.