Battery Replacement; Care And Cleaning - Health Zenith 7161 Manual

Motion Sensor:
The motion sensor is fixed with a 180° detection range.
Motion
Sensor
How The Motion Sensor Works:
The sensor detects "motion" by the movement of heat
(body heat) across the coverage area. However, following
are examples of objects that also produce heat and can
cause the sensor to false trigger:
• Pools of Water
• Dryer Vents
• Heating Vents
If you suspect that a heat source of this type is falsely
triggering the sensor, move the light fixture away from
the heat source in question.
NOTE: The detector is less sensitive to motion directly
towards it and more sensitive to across motion.
Motion
Least Sensitive

CARE AND CLEANING

• To prolong the original appearance, clean the light
fixture with clear water and a soft, damp cloth only.
• Do not use paints, solvents, or other chemicals on this
light fixture. They could cause a premature deterioration
of the finish. This is not a defect in the finish and will
not be covered by the warranty.
• Do not spray the light fixture with a hose or power
washer.
• Air Conditioners
• Fenced-In Animals
• Automobile Traffic
Motion
Sensor
Most Sensitive
GENERAL ELECTRICAL AND
SAFETY WARNINGS
• Do not immerse components in liquid.

BATTERY REPLACEMENT

IMPORTANT: Properly dispose of drained batteries.
1. Press the bottom tab of the wall mounting plate and
slide the light fixture up and off of the mounting plate.
2. Remove the battery cover on the back of the light
fixture and remove the old batteries.
3. Install three new 1.5V "C" batteries into the battery
compartment. Make sure the polarity of the batteries
is correct.
4. Replace the battery cover.
5. Place the top rear of the light fixture over the wall
mounting plate and slide the fixture down onto the
wall mounting plate. Slide the light fixture down until
the bottom tab clicks and locks the light fixture into
place.
"C" Batteries
4
E C
S I Z
E N
S E
O P
L O
S C
E S
P R
Battery
Cover
208882-02